Honeywell RedLINK Installation Manual page 12

RedLINK Installation Guide (EIM)
TM
System test
Follow the procedure below to test for proper operation.
To begin, press and hold the
until the display changes (about 3 seconds).
System test
02 Wireless test
04 Return air sensor
10 Heating system
20 Emergency heating
system
30 Cooling system
40 Fan system
70 Thermostat information
(for reference only)
CAUTION: EQUIPMENT DAMAGE HAZARD. Compressor protection (minimum
off time) is bypassed during testing. To prevent equipment damage, avoid cycling
the compressor quickly.
69-2091EFS—07
M28488
and buttons
s t
System status
0 Off
1 Test radio signal (after a brief pause, screen displays 1-10 to show
signal strength; 5 or higher recommended)
Screen displays return air temperature if device is installed and
working properly
0 Heat and fan turn off.
1 Heat turns on
2 Stage 2 heat turns on
3 Stage 3 heat turns on
0 Heat and fan turn off
1 Heat and fan turn on
0 Compressor and fan turn off
1 Compressor and fan turn on
2 Stage 2 compressor turns on
0 Fan turns off
1 Fan turns on
71 Software revision number (major revisions)
72 Software revision number (minor revisions)
73 Configuration identification code (major)
74 Configuration identification code (minor)
75 Production configuration date code (week)
76 Production configuration date code (year)
12
System test number
02
Done
Back
Press or
s t
NEXT
Press to advance to next test
DONE
Press to terminate system test
System status
0
Next
to check system status
M28489