Honeywell RedLINK Installation Manual page 7

Link remote control to wireless network (optional)
WIRELESS SETUP
Press to link
another EIM
YES
CONNECT MORE?
Link outdoor sensor to wireless network (optional)
Press and release
Français : voir la page 21 • Español: vea la página 41
CONNECT
M28481
Press to save
and exit
NO
M28482
M28483
1 Make sure the Connected light on the
EIM is flashing (see page 5).
2 Press CONNECT at the remote. There will
be a short delay as the remote seeks a
signal from the wireless network.
3 When the screen displays "Connected,"
press DONE.
4 Press NO at the next screen to save and
exit. (Or press YES and repeat steps 1-4
to link another EIM.)
If E1 appears, see error codes on page 14.
The linking procedure may time out if there is
no keypress within 30 minutes. To begin again,
press and hold the blank space (or arrow, if
present) in the lower right corner of the screen
until the display changes (about 3 seconds).
1 Make sure the Connected light on the
EIM is flashing (see page 5).
2 Press and release the CONNECT button
on the back of the sensor.
3 Check thermostat to verify that the
outdoor sensor is working. After about
15 seconds, the thermostat should
display outdoor temperature and
humidity.
(If you are installing more than one EIM,
repeat steps 1-3 for each.)
7 69-2091EFS—07