Network Settings - Cisco 8831 Installation Manual

Unified ip conference phone

Hide thumbs Also See for 8831:

Table of Contents

Cisco Unified IP Conference Phone 8831 Installation

1 The specified LED buttons flash on and off during the various stages of boot up as the conference phone

checks its hardware. See the following table for a list of the hardware test and the LED diagnostic status.

Table 4: LED Diagnostic Status

2 The screen displays the Cisco Systems, Inc., logo screen.

3 The screen displays the Revolabs, Inc., splash screen

4 This message appears as the conference phone starts up.

5 The home screen displays:

If the conference phone successfully passes through these stages, it has started up properly. If the conference

phone does not start up properly, see

Network Settings

If you are not using DHCP in your network, you must configure these network settings on the conference

phone after installing it on the network:

• IP address

• IP subnet information (subnet mask)

• TFTP server IP address

• You also may configure the domain name and the DNS server settings, if necessary.

Collect this information and see the instructions in the "Cisco Unified IP Conference Phone settings" section

of this guide.

Table of Contents