Cisco 8831 Installation Manual page 9

Cisco Unified IP Conference Phone 8831 Installation
Procedure
Step 1 Align the ferrite bead with the head of the network cable and move the ferrite bead along the cable until there
is a gap of 1.0 mm +/- 0.3 mm between the bead and the connector.
Step 2 Place the cable into the ferrite bead channel and loop the cable around the ferrite bead so that the cable exits
the bottom of the bead.
Step 3 Hold the cable in the ferrite bead channel and close the ferrite bead. Snap the latch closed.
Install Cisco Unified IP Conference Phone 8831
Before you install a conference phone, even if it is new, upgrade the conference phone to the current
Note
firmware image. Before using external devices, see the Readme file for safety and performance information.
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager 9.0
Install Cisco Unified IP Conference Phone 8831
9