Operating Elements And Terminal Strips - AEG THYRO-A Operating Instructions Manual

4.11 Operating elements and terminal strips

This chapter describes all terminal strips and connectors.
Opener, in case of fault closed
(K1) Closer, in case of fault open
Root, common connection
System interface
Control ground
Connection to slave with 2A
Connection to slave with 2A
Control ground
RxD / connection to bus module
TXD / connection to bus module
Bus module recognition
Earth potential or if necessary screen tripping device
Analog output 0-10V or 0(4)-20mA
+ 5V output e.g. for an actual value poti (5k
Sync. In (SYT-9 / QTM, see also chapt. 4.4)
Sync. Out (QTM)
Control ground
Analog set point input max. 10V, max. 20mA
Control ground
Pulse lock (PULSE INHIBIT)
Control ground
24V additional voltage supply a.c. or d.c.
24V additonal voltage supply a.c. or d.c.
L2/N supply connection - synchr. voltage supply freq.
L2/N supply connection . synchr. voltage supply freq.
X4 internal current transformer connection
X350 test jumper
X2 is not applicable with the slave components of Thyro-A 2A
Fig. 4 Terminal plan
RM 5.08
RM 3.5
RM 3.5
R 10k )
Poti
RM 3.5
RM 3.81
RM 3.81
87