Step 1: Configuring The Client-To-Gateway Vpn Tunnel On The Fvg318 - NETGEAR ProSafe FVG318 Reference Manual

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
• "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 6-10
configures the NETGEAR ProSafe VPN Client endpoint.
FVS318v3
192.168.3.1
PCs
Figure 6-3
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
FVG318
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
not covered by these VPNC-recommended parameters, refer to
"Advanced Virtual Private
Follow this procedure to configure a client-to-gateway VPN tunnel using the VPN Wizard.
6-6
VPN Tunnel
24.0.0.1
Table 6-1 on page
Networking" to set up the VPN tunnel.
v1.0, October 2005
PC
(Running NETGEAR
ProSafe VPN Client)
6-4. If you have special requirements
Chapter 7,
Basic Virtual Private Networking