Makita 2012NB Instruction Manual page 7

1
2
1mm (3/64")
003718
Grip the magnetic holder and slip the heel of the set plate
into the groove in the drum. Install the blade installation
bolts.
1
2
4
5
003716
After tightening all the blade installation bolts lightly and
evenly from the center to the outside, tighten them
completely following the same sequence. Remove the
magnetic holders from the set plate.
1
2
003717
Install the other blade as described above. Rotate the
drum slowly while pressing the lock plate to make sure
there is nothing abnormal. Then install the chip cover and
the side cover.
CAUTION:
Do not tighten the blade installation bolts without
•
the blade locating lug of the set plate correctly
resting in the groove of the blade. This may cause
damage to the blade and potential injury to the
operator.
Do not turn the tool on with the chip cover removed.
•
For standard blades only
Place the blade on the blade gauge so that the blade edge
is perfectly flush with the inside of the front rib (A). Place
the set plate on the blade, then gently press the heel of the
set plate flush with the back side of the blade gauge (B).
Tighten the screws to secure the set plate to the blade.
1. Magnetic holder
3
2. Set plate
3. Blade
1. Blade installation
3
bolts
2. Set plate
3. Magnetic holder
4. Drum
5. Blade
6. Claw
6
1. Socket wrench
2. Magnetic
holders
1
B
3 4
004470
Slip the heel of the set plate into the groove in the drum.
Install the blade installation bolts.
1
2
004471
After tightening all the blade installation bolts tightly and
evenly from the center to the outside, tighten them
completely following the same sequence.
1
2
004472
Install the other blade as described as above. Rotate the
drum slowly while pressing the lock plate to make sure
there is nothing abnormal. Then install the chip cover and
the side cover.
CAUTION:
Tighten the blade installation bolts securely when
•
installing the blades.
Do not turn the tool on with the chip cover open.
•
Changing type of blade
This tool can accept either throw away blades or
standard blades. If you wish to change the type of blade,
buy and use the following parts.
Changing from standard blade
to throw-away blade
Set plate ---------------------- 2 pcs.
Throw-away blade (306 mm) --- 2 pcs.
Magnetic holder ---------------- 2 pcs.
006417
7
1. Screw
2. Set plate
2
3. Blade
4. Blade gauge
A
1. Set plate
2. Groove
3 3. Blade
4. Drum
4
1. Socket wrench
2. Lock plate
3. Blade installation
bolt
3
Changing from throw-away blade
to standard blade
Set plate ------------------ 2 pcs.
Pan head screw M 4 x 6 ----- 4 pcs.
Standard blade ------------- 2 pcs.
Blade gauge ----------------1 pc.