Makita PJ7000 Instruction Manual page 5

1
6
5
7
2
3
012254
To adjust the angle guide height, loosen the lock lever
down and rotate the knob until the pointer points to the
desired scale graduation marked on the angle guide.
Then tighten the lock lever up to secure the angle guide.
The scale on the angle guide indicates the distance from
the top of the workpiece to the center of the blade
thickness.
1
012255
The angle guide is removable from the fence according
to the need of your work. To remove the angle guide,
loosen the lock lever and turn the knob clockwise until it
comes out of the upper end of the fence.
Fence
NOTE:
Remove the angle guide according to the need of
•
your work when using the tool with the angle of the
fence adjusted to other than 0 ﾟ. When you need to
use the angle guide under the above condition, be
sure to adjust the depth of groove to get a proper
depth.
The angle of the fence can be adjusted between 0° and
90° (positive stops at 0°, 45° and 90°). To adjust the
angle, loosen the lock lever and tilt the fence until the
pointer points to the desired graduation on the angle
scale. Then tighten the lock lever to secure the fence.
1
5
4
012256
1. Lock lever
2. Angle guide
3. Knob
4. Scale
5. Pointer
6. Tighten
7. Loosen
4
1. Knob
2. Down
3. Up
4. Center of blade
2
thickness
3
4
1. Fence
2. Lock lever
3. Angle scale
4. Tighten
5. Loosen
2
3
When the fence is set at 90°, both the distance from the
center of the blade thickness to the fence and the
distance from the center of the blade thickness to the
bottom of the blade cover are 10 mm (0.4").
1
2
3
10mm
10mm
4
012257
Set plate
Use the set plate as shown in the figures when cutting
slots in thin workpieces.
2
5: 3
4mm
4
10mm
10mm
6
6mm
012258
1
012259
Switch action
012271
CAUTION:
Before plugging in the tool, always check to see
•
that the slide switch actuates properly and returns
to the "OFF" position when the rear of the slide
switch is depressed.
5
1. Lock lever
2. Pointer
3. Angle scale
4. Center of blade
thickness
5. Blade cover
5
1. Lock lever
1
2. Pointer
3. Angle scale
4. Set plate
5. Thickness of set
plate
6. Center of blade
thickness
7
7. Blade cover
1. Set plate
1. Slide switch
1