Installation; Functional Description - Makita 2012NB Instruction Manual

INSTALLATION

Movement and transport of planer
1
2
CAUTION:
• Watch your step when moving the tool.
Fold the sub-tables. Grasp the carrying handles when
moving the tool.
When transporting it by vehicle, secure with a rope or
other substantial means to prevent tipping or movement.
Positioning the planer
Locate the tool in a well lit and level place where you can
maintain good footing and balance. Bolt/screw it to the
workbench or planer stand (optional accessory) using
the bolt holes provided in the base.

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
1
2
003707
1. Carrying handle
2. Sub-table
003708
1. Bolt or screw
1
003709
1. Pilot lamp
2. Key
3. Switch lever
3
CAUTION:
• Before plugging in the tool, always be sure that the
tool is switched off. The pilot lamp lights up when
the tool is plugged into the power source.
To start the tool, insert the key and raise the switch lever.
To stop it, lower the switch lever.
CAUTION:
• When not using the tool, remove the key and store
it in a secure place. This prevents unauthorized
operation.
Dimensional adjustment
1
2
3
Lower the main frame by turning the crank handle coun-
terclockwise until the indicator plate points to the scale
graduation indicating the desired finished dimension.
One full turn of the crank handle moves the main frame 2
mm (3/32") up or down. The scale has inch graduations
on its right side and metric graduations on its left side.
Adjusting depth of cut
The maximum depth of cut differs depending upon the
width of workpiece being cut. Refer to the table. When
you need to remove more than the amount specified in
the table, set the depth of cut shallower than the amount
and make two or more passes.
Width of workpiece being cut
Less than 150 mm (5-7/8")
150 mm (5-7/8") - 240 mm (9-1/2")
240 mm (9-1/2") - 304 mm (12")
To adjust the depth of cut, proceed as follows.
Insert the workpiece flat on the table top. Lower the main
frame by turning the crank handle counterclockwise. The
depth gauge will rise and the amount of gauge rise indi-
cates the depth of cut.
4
003710
1. Crank handle
2. Scale
3. Indicator plate
4. Main frame
4
003711
Maximum depth of cut
3.0 mm (1/8")
1.5 mm (1/16")
1.0 mm (3/64")
003712
1. Depth gauge
1