Table of Contents
Advertisement
Instructions for Installation (cont'd)
Typical Installation
CHECKALL CONNECTIONS FOR LEAKS. CONSULTTHE LOCAL UTILITY COMPANY TO EXAMINE INSTALLATION FOR PRO-
PRIETYAND SAFETY.
VACUUM RELIEF R EQUIRED B Y SOME CODES
_
(REFER T O LOCAL CODES)
HOTWATER OUTLET
gem
TOCHIMNEY _-_
COLD WATER INLET
TEMPERED _
_
_
_
W, TEROUT'ET
*MIXINGVALVE ]
GAS I
SUPPLY
-- TEMPERATURE-PRESSURE
RELIEF V ALVE
DISCHARGE PIPE
R[_
_--
--
(Do notcapor plug)
_
_ DRAIN VALVE
V
DRA
__'_
TOSUITABLE DRAIN
This appliance has been design certified as complying with American National Standard/CSA Standard for water heaters and is con-
sidered suitable for.
Water (Potable) Heating: Al1 models are "considered suitable for water (potable) heating."
AWARNING
.
A WARNING
to anyheat-
HOTTER WATER CAN SCALD: Water
heaters
are
This water heater shall not be connected
intended
to produce
hot water, Water heated to a
ing systems or component(s) previously used with a
temperature
which
will satisfy clothes washing,
non-potable water heating appliance.
dish washing, and other sanitizing needs can scald
and permanently
injure you upon contact. Some
people are more likely to be permanently
injured by
hot water
than others. These include the elderly,
A WARNING
[
children,
the infirm,
or physically/mentally
hancli-
I
capped. If anyone using hot water in your home fits
Toxic chemicals such as used for treatment of boilers
into one of these groups or if there is a local code or
or non-potable water heating appliances shall never J
be introduced
into a potable water space heating
system.
state law requiring a certain temperature
water at
the hot water tap, then you must take special pre-
cautions. In addition
to using the lowest possible
temperature
setting that satisfies your hot water
needs, a means such as a mixing valve, should be
used at the hot water
taps used by these
people
or
NOTE: To protect against untimely corrosion of hot and
at the water heater.
Mixing valves
are available
at
cold water fittings, it is strongly recommended that di-elec-
plumbing
supply or hardware
stores. Follow manu-
tric unions or couplings be installed on this water heater
tacturers
instructions
for installation
of the valves.
Before changing
the factory setting on the thermo-
when connected to copper pipe.
stat, read the "Temperature
Regulation"
section in
this manual.
10
Hide quick links:
Advertisement
Table of Contents
