Item
Latitude
Longitude
Altitude
Speed
Heading
Satellites
GPS Settings
Enable GPS
Use Metric units
GPS mode
Settings Page
From the Settings page, you can configure your device and network settings.
General > Device Tab
From the General > Device tab of the Settings page, you can turn your device's OLED display
on/off, choose the type of data usage to show on the OLED display, and configure the Web browser
URL and IP Address.
1. Log in to the home page. (See Logging In as an Administrator.)
NETGEAR 341U Manager Interface
Latitude at time of last fix. (For example, "N32.51.73")
Longitude at time of last fix. (For example, "W105.11.7")
Elevation at time of last fix. (For example, "40 meters")
Speed at which device was moving at time of last fix. (For example,
"3.1 mph")
Direction in which device was moving at time of last fix. (For example,
"East")
The number of satellites used to get the last fix.
Turns the GPS service on or off. See Enabling / Disabling GPS.
Note: For best results, minimize the number of obstructions between your
device and the GPS satellites.
This setting specifies whether to use metric units when displaying the GPS
results (for example, for altitude, speed, and HEPE). See Using Metric
Units.
This setting determines how often your device should obtain a fix. See
Setting the GPS Mode.
One-time – A single fix is used. Use this option if you'll be using your
n
device at the same location.
Continuous – Fixes are obtained every few seconds (also known as
n
auto-tracking). This is useful for turn-by-turn (TBT) navigation
applications, such as driving directions, and for NMEA-enabled
applications.
Description
23