Connect Using Wps Push-Button Method - Buffalo LPV4-U2-300S User Manual

7
Wait about 30 seconds and check the LEDs on the side of the print server.
Note: If the wireless LED is blinking, the connection could not be established. Check the access point and its
encryption key and try again.

Connect Using WPS Push-Button Method

If your wireless access point has a WPS/AOSS button, you can use it to connect the print server wirelessly.
Before starting, the print server's connection method should be set to "Auto".
1
Connect the AC adapter to the print server. If the print server was using a wired connection, disconnect both the
Ethernet cable and the AC adapter from the print server and then re-connect the AC adapter only.
2
Wait for about 30 seconds, then press and hold the WPS button for about 5 seconds.
3
Press the access point's WPS or AOSS button.
Note: If you are using Buffalo router, press and hold the AOSS button for at least two seconds to start WPS. This may
be different for other access point devices.
8