Connect Using WPS PIN Method
You can use WPS to connect the print server wirelessly by registering the print server's WPS PIN with your wireless
access point. The print server's WPS PIN can be obtained from Settings. To open Settings, refer to the "Accessing Settings"
section below.
Before starting, the print server's connection method should be set to "Auto".
1
Set up the print server on a wired connection then log in to Settings.
2
Navigate to Network - Wireless LAN - WPS Settings and click Execute WPS.
3
Within 2 minutes, register the displayed PIN with the target access point.
4
Confirm that "WPS Success" is displayed from Settings. If the following window is not displayed, the connection
could not be established. Try again.
5
Disconnect the Ethernet cable from the print server.
6
Disconnect the AC adapter; wait about 10 seconds and reconnect it.
7