Switch From Wired To Wireless Connection; Switch From Wireless To Wired Connection - Buffalo LPV4-U2-300S User Manual

Refer to the example below (if network is on 192.168.11.0).
DHCP - Disabled
IP address - 192.168.11.222
Subnet mask - 255.255.255.0
Default gateway - 192.168.11.1
WINS server - 0.0.0.0
Note: Only assign the print server a valid IP address, otherwise Settings cannot be accessed. If you cannot open
Settings, initialize the print server, which restores all settings to factory default.
4
When "Restart the print server to save the settings. Restart now?" is displayed, click OK.

Switch from Wired to Wireless Connection

The print server cannot use both a wired and a wireless connection at the same time. To switch from a wired connection
to a wireless connection, refer to the Chapter 1 section "Connecting with a Wireless Connection".

Switch from Wireless to Wired Connection

Follow the procedure below to switch wireless connection to wired connection. The print server cannot use both wired
and wireless connection at the same time.
Before starting, check that the connection method is 'Auto' .
1
Disconnect the AC adapter from the print server.
2
Connect the print server to the router or hub with an Ethernet cable.
3
Connect the AC adapter to the print server.
4
Wait for about 30 seconds, then check the LEDs on the side of the print server.
44