Camera Mpeg Settings - GE SymDec 4 User Manual

26 SymDec 4
User Manual
The advanced mode screen has settings for:
• The Streaming Port
• Streaming Address
• Sender Control Enable
• Sender Control Port
• Receiver Control Enable
• Receiver Control Port
These settings must match exactly between the multicast device and any device which wants the stream.
Note: Configured incorrectly IP multicast can become a serious drain on your networks resources! If you are at all uncertain
on how to setup IP multicast, please contact your network administrator or IS professional.

Camera MPEG Settings

This page provides settings that have to do with MPEG quality and speed. Three quality settings are available;
standard, medium, and high. The MPEG preset settings control the video latency (delay). Selecting the low
latency preset can increase the speed of the video, but the quality will suffer. Field rate and resolution settings
are also available. Up to 15 custom configurations can also be setup and saved on this page. Audio can also be
turned on of off by camera.You can also change the camera titles here.
Figure 18. MPEG settings screen