Specifications - Makita LS1040 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model
Blade diameter
Hole diameter
For all countries other than European countries
For European countries
Max. Cutting capacities (H x W) with blade 260 mm in diameter
Bevel angle
0°
45° (left)
-1
No load speed (min )
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
･
Do not place hand or fingers close to
the blade.
･
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
･
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure
to do so may cause serious injury to
operator.
･
To loosen the bolt, turn it clockwise.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
93 mm x 95 mm
69 mm x 135 mm
53 mm x 95 mm
35 mm x 135 mm
END217-3
equipment and
Miter angle
0°
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model LS1040
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.30 Ohms it can be
presumed that there will be no negative effects. The
its
mains socket used for this device must be protected with
2
LS1040 / LS1040S
25.4 mm and 25 mm
45° (left and right)
93 mm x 67 mm
69 mm x 95 mm
49 mm x 67 mm
35 mm x 94 mm
530 mm x 476 mm x 532 mm
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally
recycling facility.
255 mm -260 mm
30 mm
4,600
12.4 kg
/II
compatible
ENE004-1
ENF002-1
ENF100-1