Cleaning Recommendations - Oral-B 3731 Smart Manual

Wall mount
If you prefer to mount the SmartGuide display
unit on a wall, mirror or other surface, use
the adhesive tape (k) to fix the wall mount.
Before doing so, make sure the chosen surface
is clean and dry (remove grease and dust first).
Position the wall mount so that the Oral-B logo
is readable. Then, press the wall mount evenly
and firmly to the wall. Wait 24 hours before
sliding the SmartGuide display unit into the fixed
wall mount.
Please note: The adhesive tape will not work on
dirt-repellent surfaces.

Cleaning recommendations

• After brushing, rinse your brush head
thoroughly under running water.
• Remove the brush head from the handle and
clean both parts separately under running
water. Then, wipe them dry before you put the
handle on the charging unit.
• Before cleaning your charging unit, make sure
you disassemble it first. The charging ring and
SmartPlug should never be placed in the dish-
washer. However, all other parts (base plate
and protective cover) are dishwasher-safe.
• From time to time, you can also clean the
charging ring, SmartPlug and SmartGuide
display unit with a damp cloth. Both the
SmartPlug charger and SmartGuide display
unit should never be placed in water.
Synchronizing
In order to avoid interference of display
messages when using more than one Oral-B
Professional Care SmartSeries 5000 toothbrush
with separate SmartGuide display units in the
same household, you need to assign the
handles to their respective display units. Please
follow the steps below:
• Push the «h/min» button in the battery
compartment for at least 3 seconds. The
SmartGuide display unit shows «L---», in-
dicating the «Learn» mode for synchronization
is activated.
• Now you are requested by a flashing
on/off button in the toothbrush icon on the
SmartGuide display unit to turn the handle on.
When doing so, the automatic synchronization
process starts. It is finished when «L-1-» is
displayed.
h/min h/min
3 sec. 3 sec.
• Then turn off the handle.
If you would like to assign a second handle to
the same SmartGuide display unit, repeat the
last two steps described above with the other
handle. You can exit the «Learn» mode by
pressing the «h/min» or «set» button. Otherwise
the «Learn» mode will automatically end after
30 seconds.
Please note:
• A maximum of 2 handles can be synchronized
with one SmartGuide display unit. After you
synchronized the second handle, «Full» will be
displayed.
9