Makita BHS630 Instruction Manual page 9

NEVER tape down or defeat purpose and function
•
of lock-off lever.
Lighting the lamp
CAUTION:
Do not look in the light or see the source of light
•
directly.
012106
Only to turn on the light, pull the switch trigger without
pressing the lock-off lever. To turn on the light and run
the tool, press the lock-off lever and pull the switch
trigger with the lock-off lever being pressed.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Do not use gasoline, thinner or the like to clean the
•
lens of lamp. Using such substances will damage
the lens.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing saw blade
CAUTION:
Be sure the blade is installed with teeth pointing up
•
at the front of the tool.
Use only the Makita wrench to install or remove the
•
blade.
3
2
012094
1. Light
1
1. Shaft lock
2. Hex wrench
3. Loosen
1
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
hex bolt counterclockwise. Then remove the hex bolt,
outer flange and blade.
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
CLOCKWISE SECURELY.
2
1
012096
When changing blade, make sure to also clean upper
and lower blade guards of accumulated sawdust. Such
efforts do not, however, replace the need to check lower
guard operation before each use.
Hex wrench storage
012097
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Connecting a vacuum cleaner (for European
countries only)
1
012113
9
1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
4
3
1. Hex wrench
1
1. Dust nozzle
2. Thumb screw
2