Optional Accessories; Replacing Carbon Brushes - Makita BHS630 Instruction Manual

1
012103
This adjustment has been made at the factory. But if it is
off, adjust the adjusting screw with a hex wrench while
inspecting 90°the blade with the base using a triangular
rule or square rule, etc.
Adjusting for parallelism
1
2
A
B
012101
The parallelism between the blade and the base has
been factory adjusted. But if it is off, you can adjust it as
the following procedure.
Make sure all levers and screws are tightened. Slightly
loosen the screw as illustrated. While opening the lower
guard, move the rear of base so that the distance A and
B are equal. After adjusting, tighten the screw. Make a
test cut to get a correct parallelism.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
1. Triangular rule
2
2. Saw blade
1. Base
3
2. Screw
3. Saw blade
1. Limit mark
1
1
2
012114
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Saw blades
•
Rip fence (Guide rule)
•
Hex wrench 5
•
Dust nozzle
•
Guide rail adapter
•
Guide rail
•
Various type of Makita genuine batteries and
•
chargers
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
11
1. Brush holder
cap
2. Screwdriver
or attachments
Only use accessory or
are