Makita 6802BV Instruction Manual page 8

When using insert bit
Fit together the insert bit and magnetic
bit holder
as
shown in the figure on the
right. Install a locator assembly for an in-
sert bit.
Then adjust depth setting. Initially, adjust
the locator assembly to create
a
distance of
approximately 1 mm (3/64") from the tip
of the locator to the base of the screw
head. Continue adjusting until the proper
depth setting is obtained by following the
method of "Depth adjustment".
Locator
-
Insert bit
L
\
Magnetic bit holder
1
r------
1 mm (3/64")
L
To remove the bit, pull the magnetic bit holder firmly. Hold the magnetic bit holder in
your hand and grasp the bit with a pair of pliers. Pull the bit out of the magnetic bit
holder. Sometimes,
it
helps to wiggle the bit with the pliers
as
you pull.
8