Makita 6802BV Instruction Manual page 7

Reversing switch action
This tool has
a
reversing switch to change
the direction of rotation. Move the revers-
ing switch lever to the
&
position for
clockwise rotation or the @ position for
counterclockwise.
CAUTION :
0
Always check the direction of rotation before operation.
*Use the reversing switch only when the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may ruin the tool.
r
Reversing switch lever
Operation
Fit the screw on the point of the bit and
place the point of the screw on the surface
of the workpiece to be fastened. Apply
pressure to the tool. Start the tool slowly
and then increase the speed gradually.
Withdraw the tool as soon as the clutch
cuts in.
CAUTION
:
0
Use the proper bit for the head of the screw that you wish to use.
0
When fitting the screw onto the point of the bit, be careful not to push in on the screw.
If the screw i s pushed in, the clutch will engage and the screw will rotate suddenly. This
could damage
a
workpiece or cause an injury.
0
Do not continue unnecessary clutching operation.
NOTE
:
Make sure that the bit is inserted straight in the screw head, or the screw and/or bit may
be damaged.
7