Makita 6802BV Instruction Manual page 6

Variable speed/ reversing

Hide thumbs Also See for 6802BV:

Initially; adjust the locator assembly to

create a distance of approximately 0.5 mm

(1/64") from the tip of the locator to the

tip of the socket bit. One full turn of the

locator equals 1.5 mm (1/16") change in

depth. After adjusting the locator assembly,

push the locking sleeve in to lock the

locator in place. Drive a trial screw into

your material or a piece of duplicate mate-

rial. If the depth i s not suitable for the

screw, continue adjusting until the proper

depth setting i s obtained.

Switch action

Tool speed is increased by increasing pres-

sure on the trigger. To start the tool,

simply pull the trigger. Release the trigger

to stop. For continuous operation, pull the

trigger and then push in the lock button.

To stop the tool from the locked position,

pull the trigger fully, then release

it.

CAUTION :

0.5 mm

( 1

/64")

Locator

Trigger switch

Lock button

Before plugging in the tool, always check to

see

that the trigger switch actuates properly

and returns to the "OFF" position when released.

NOTE :

Even with the switch on and motor running, the bit will not rotate until you fit the point

of the bit in the screw head and apply forward pressure to engage the clutch.