Specifications - Makita GA5010 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Depressed center wheel diameter
Rated speed (n)/ No load speed (n
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Wear safety glasses.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Model
Spindle thread
)
0
Overall length
Net weight
Safety class
equipment
GA5010
11000 min
356 mm
END202-6
Noise
The typical A-weighted noise level determined according
to EN60745:
Model GA5010
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model GA6010
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
and its
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Model GA5010,GA6010
ENE048-1
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENF002-2
If the tool is used for other applications, the vibration
values may be different.
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
2
GA5011 GA6010
125 mm
M14
-1
384 mm 356 mm
2.6 kg
/II
) : 89 dB(A)
pA
) : 100 dB(A)
WA
) : 90 dB(A)
pA
) : 101 dB(A)
WA
Wear ear protection
) : 9.5 m/s
h,AG
2
GA6011
150 mm
M14
-1
10000 min
384 mm
2.7 kg
ENG905-1
ENG900-1
2
ENG902-1