Table of Contents
Advertisement
13.1
To check remote access code
In standby mode, press the OK/MENU button.
or down
Press the up
Press the OK button
>The default code is "321".
Press the stop button
>See "7.7 Remote access" for how to change your code.
13.2
To check your messages from a remote location
Using a tone dialling phone, dial your home phone number.
Press * during the OGM to stop it playing or wait until the OGM finishes.
Enter your remote access code.
>If the code is accepted, a list of options will be heard.
>If the code is not recognised you will hear no feedback and you will need to enter it again. Please
note that if the code is entered incorrectly three times consecutively, the call will be terminated
automatically.
Press 2 to playback your messages.
>For other instructions, see next section.
Notes:
During remote operation and when messages are not being played, you must press a key within
10 seconds, otherwise the machine will cut off your call.
During remote operation, the playback is paused automatically after about 3 minutes and to
continue the 2 key must be pressed within 10 seconds, or the machine will cut off your call.
13.3
Using the remote instruction codes
When you first enter remote access mode and after each remote action, you will hear a list of options.
The available remote instruction codes are:
Press 2 to start playing new recorded messages, or if there are no new messages to start playing
old messages.
>After playing back new messages, press 2 again to play all recorded messages.
>To pause and restart during message playback, press 2. Playback can be paused for up to
30 seconds, but after that the playback automatically restarts.
Press 1 to repeat the current message.
Press 1 twice to skip back to the previous message.
Press 3 to skip forward to the next message.
Press 4 to play the current announcement.
Press 5 to record a new announcement.
Press 6 to stop a recording or playback.
Press 7 to delete the current message.
Press 8 to turn the answering machine off.
Press 9 to turn the answering machine on.
>Press 9 to switch between OGM1 and OGM2.
Press 0 twice quickly to delete all old messages.
>There could be a delay while the delete is being done, before you hear a beep and the menu list
again.
Press # to disconnect the call.
13.4
Switching on from a remote location
If the answering machine is switched off, it will answer your call after 15 rings allowing you to switch the
machine on from a remote location.
Using a tone dialling phone, dial your home phone number.
When you hear the outgoing message, key in a *, followed by your remote access code.
Press keypad 9 to switch on.
button until the display shows "REMOTE ACCESS".
to display your code setting.
to return to standby mode.
17
Advertisement
Table of Contents
