Table of Contents
Advertisement
System Setup
Examples
Rev 1.01
Notes
If no timers are enabled—that is, ↓ displays—the VCR responds to the ignition trigger only.
When any timer is enabled, the VCR turns on with the ignition signal, but does not start
recording until the current time is within the timer start and stop times. The only exception
to this rule is if the stop time is earlier than the start time, the VCR records through midnight,
provided the vehicle is running.
11:00P 02:30A↑ means that the VCR starts recording at 11:00 PM and stops recording at
2:30 AM, provided the vehicle is running.
To record for 23 hours and 59 minutes, set the start time to 12:05A↑ and the stop time to
12:04A.
When the timers are on, the VCR will not record unless the trigger is active (for example, the
bus ignition is on) or the delay-off time has not ended.
When two or more timers do not overlap in time, the VCR starts and stops according to the
timer schedule.
When two or more timers overlap chronologically, the earliest start time and the latest stop
times are considered.
22
Document 900.0341
12/05
Advertisement
Table of Contents
