Table of Contents
Advertisement
RES
Resets all the programmable parameters of the VCR to factory defaults. This option is useful if
System
the unit experiences intermittent programming.
Reset
There are two ways to reset to factory defaults:
•
If you want the system to ask for confirmation of a reset:
a.
b.
•
To reset without confirmation, press once, then move forward or backward with the FF or
REW buttons.
MPH
When an HTRGPS module is installed and connected, the VCR can be programmed to accept
GPS data. This field indicates whether the speed of the vehicle records in MPH (miles per hour)
or KPH (kilometers per hour).
DIR
Enable (↑) or disable (↓) display of vehicle direction from HTRGPS module.
(Direction)
LL
Enable (↑) or disable (↓) display of vehicle location from HTRGPS module.
(Latitude,
longitude)
DT1 to DT5
Daily timers. The setup of the timers is based on a 12-hour display as:
12:00A 12:00A
Up to five timers can be programmed. Each timer includes a start time (first time), a stop time
(second time) and the arrow indicator that enables (↑) or disables (↓) the timer. It is not
necessary to reset the start and stop time.
Rev 1.01
Press once to change the text to CON.
Press a second time. The reset takes effect and the parameters are reset to the factory
defaults (see
Figure
3-3).
Lines 7 to 11
HTR62 Installation and Operating Guide
21
Document 900.0341
12/05
Advertisement
Table of Contents
