Black & Decker NPS9010 Instruction Manual page 9

Cordless power scrubber
Table of Contents

Advertisement

Available languages

Available languages

90513658
NPS1018
1/15/07
2:02 PM
The additional second center extension (C) (green connectors)
may not be included in all kits and is available as an accessory and
may be connected to the provided center extension (B) (orange).
The provided center extension has orange connectors. The
accessory center extension had green extensions. The orange
center extension may be connected to the handle, and the green
extension may be connected to the orange center extension The
green center extension WILL NOT fit into the Handle Module (A).
Disassembly
Detaching Modules
WARNING: To prevent accidental operation, insure that
battery is removed from the tool before performing the following
operations. Failure to do this could result in serious personal injury.
When detaching the modules, whether it is in the two, three or four
module mode, always detach the power head module first. To do this,
rest the handle module on the ground and grasp the center of the
power head module with one hand as show in figure 17. Use your
other hand to loosen the threaded sleeve as shown in figure 18 and
then pull the two halves apart. Repeat this process if the center
extensions were attached.
17
Page 9
18
Operating the Power Scrubber
Connecting the Battery
• Unscrew the battery cover (2) counter-clockwise
from the Handle Module, 1/4 of a full revolution and then pull away
from handle.
• Insert the battery in the Handle, figure 19 and
be certain that it is fully into the handle cavity
until it "clicks" into place. Re-install the cover by
aligning the threads and screwing on in a
clockwise direction until firmly attached.
Transporting Power Scrubber
• Always remove the battery pack from the handle (figure 19) and
remove the brush (figure 8) when transporting the Power
Scrubber.
WARNING: Ensure that the Battery Cover is installed and fully
tightened. Failure to do so could allow water intrusion.
• To remove the battery, remove the cover as above, then press
down on the release button on the back of the battery (figure 20)
and slide out. Re-install the battery
cover.
9
19
20

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nps1018

Table of Contents