Advertisement
Switch action
To start the tool, simply pull the trigger.
Fig. 1:
CAUTION :
Before plugging in
the
tool, always check to see that the trigger switch actuates properly
and returns to the "OFF" position when released.
Operation
Grasp the rear handle with your right hand
and the front grip with your left. Maintain
proper balance and control. Set the saw
base on the workpiece to be cut with i t s
guide plate contacting flush against the side
of the workpiece and without the blade
making any contact. Turn the tool on and
wait until the blade attains full speed. Now
simply move the tool forward over the
workpiece surface, keeping it flat and
advancing smoothly until the cut is com-
pleted. The guide plate will cause the tool
1
\
\
Rear handle
Front grip
t o cut perpendicularly
( 9 0 ' )
to the side
Fig. 14
of the workpiece contacted by the guide plate. When the cut is completed, turn the tool
off and wait until the blade has come to a complete stop. Return the tool back to i t s
original position. The guide plate will return to i t s original position automatically.
CAUTION :
When you attempt to cut workpieces wider than travel distance of the guide plate or t o
perform cuts other than square cuts, remove the guide plate from the tool.
9
Advertisement
