NETGEAR CBVG834G Adminstrators User Manual page 64

Wireless Cable Voice Gateway Model CBVG834G Adminstrators User Manual
To configure remote management:
1. Under the Advanced heading on the main menu, select Remote Management. The Remote
Management screen displays:
Figure 4-7
2. Select the Allow Remote Management check box.
3. Enter the Remote User Name and Remote Password that will be required to remotely access
your gateway.
4. Enter the Port Number that will be used for accessing the management interface.
Web browser access normally uses the standard HTTP service port 80. For greater security,
you can specify a custom port by entering that number in the box provided. Choose a number
between 1024 and 65535, but do not use the number of any common service port. The default
is 8080, which is a common alternate for HTTP.
5. To make sure that you can use remote management even if the wireless voice gateway is reset,
select the Allow Remote Management after Factory Default Reset check box.
If you do not select this check box, you will not be able to remotely access the gateway if you
use the Erase feature to revert to the Factory Default settings.
6. Click Apply to have your changes take effect.
When accessing your wireless voice gateway from the Internet, type the WAN IP address of your
gateway into your browser, followed by a colon (:) and the port number. For example, if your
WAN IP address is 134.177.0.123 and you use port number 8080, type the following in your
browser:
http://134.177.0.123:8080
4-10
v1.0, February 2008
Managing Your Network