Interface Module Leds - Cisco ASR 903 Hardware Installation Manual

LED Summary
Table 5-10
LED
USB flash
(MEM)
BITS

Interface Module LEDs

Table 5-11
interface modules:
•
•
•
Table 5-11
LED
Power
(PWR)
Status
(STAT)
Link status
(L)
Speed (S)
Cisco ASR 903 Router Hardware Installation Guide
5-8
RSP LEDs (continued)
Color/State Description (two LEDs for eachT1/E1 port)
Flashing Holdover
yellow
Green Locked to source
Flashing USB activity
green
Off Out of service/not configured
Amber Fault or loop condition
Green In frame/working properly
summarizes the interface module LEDs. This LED summary applies to the following
SFP Gigabit Ethernet Interface Module
RJ45 Gigabit Ethernet Interface Module
XFP 10 Gigabit Ethernet XFP Interface Module
Interface Module LEDs
Color/State Description
Off Disabled/no power to IM
Green Enabled and power rails on IM in range
Off Disabled/power-down
Red Failure (on at reset)
Amber Booting (if local CPU)
Green Operational
Off Inactive or no connection
Amber Fault/loop condition
Green Ok with no activity
Flashing OK with activity
green
Off 100/10 Mbps/Slow
Green 1Gbps/Full
Chapter 5 Troubleshooting
OL-25178-04