Attaching The Cable Management Brackets - Cisco ASR 903 Hardware Installation Manual

Installing the Router in a Rack
Figure 3-5
Step 3 Install the 8 or 12 (4 or 6 per side) 12-24 x 3/4-inch or 10-32 x 3/4-inch screws through the holes in the
bracket and into the threaded holes in the equipment rack posts.
Step 4 Use a tape measure and level to verify that the chassis is installed straight and level.

Attaching the Cable Management Brackets

To install the optional cable management brackets, perform these steps:
Position the cable management brackets against the front of the chassis and align the four screw holes,
Step 1
as shown in
Figure 3-6
Step 2 Secure the cable management brackets with four M4 screws. The recommended maximum torque is 10
in.-lb (1.12 N-m).
Cisco ASR 903 Router Hardware Installation Guide
3-4
Installing the Chassis in a 300 mm ETSI Cabinet
Figure 3-6.
Cable Management Bracket Installation
Chapter 3 Installing the Cisco ASR 903 Router
OL-25178-04