Table of Contents
Advertisement
2G/2.5G LED
3G/3.5G LED
SMS LED
WAN LED
LAN LED
WiFi LED
How to operate
Step 1. Attach the antenna.
1.1. Remove the antenna from its plastic
wrapper.
1.2. Screw the antenna in a clockwise
direction to the back panel of the unit.
1.3. Once secured, position the antenna
upward at its connecting joint. This will
ensure optimal reception.
1.4. And rip the "USIM/SIM & PWR" sign
label from "Pull" tag.
1.Turn off the Power Switch
2.DO NOT
Step 2. Insert SIM/USIM to IAD.
NOTE:
2.1. The WiFi HSPA IAD builds in a
HSUPA 3G modem card. Please refer to
your service provider for detailed feature
information.
2.2. A 3G SIM/USIM Card with services is
MUST, the Data service and the Voice
service.
Green
Green in flash
Green
Green in flash
Green
Green in flash
Green
Green in flash
Green
Green in flash
Green
Green in flash
Green in fast flash
first.
connect WiFi HSPA
IAD to power before
performing the installation
steps below.
EDGE or GPRS connection is established
Data packet transferred via 2G/2.5G
UMTS/HSDPA/HSUPA connection is
established
Data packet transferred via 3G/3.5G
SMS storage is full
There is any unread SMS in the storage
RJ45 cable is plugged
Data access
RJ45 cable is plugged
Data access
WLAN is on
Data access
Device is in WPS PBC mode
Advertisement
Table of Contents
