Buffalo TeraStation WSS 5000 User Manual page 58

WS5400R
1
Power Button
To power on, connect the power cable and wait for 10 seconds. Then press the power button. To power off, follow
the instructions in chapter 1. Do not disconnect the power cable without shutting down the TeraStation.
2
Info LED
If there is a status message, the amber info LED is lit. Check the LCD panel.
3
Error LED
The red error LED is lit when an error occurs. Check the LCD.
4
LAN1 LED
When LAN port 1 is connected to a network, it is lit green. The LED next to LAN port 1 is also lit.
5
LAN2 LED
When LAN port 2 is connected to a network, it is lit green. The LED next to LAN port 2 is also lit.
6
LCD Panel
Displays the status of the TeraStation.
7
Display Button
Switches between the display modes. This button also stops the TeraStation from beeping.
8
Function Button
Use for recovery.
9
Drive Lock
Open the front panel with the key to replace hard drives or press the reset button.
10
Reset Button
To shut down and reboot the TeraStation, hold down the reset button.
11
Status LEDs
Normally, these LEDs blink green when hard drives are accessed. If you need to remove a drive whose status LED is
flashing red, either shut down the TeraStation, or dismount the drive in RAID Builder. Once the TeraStation is shut
down, or the drive is dismounted, then it is safe to replace the drive. If a drive is malfunctioning, its status LED will
be glowing red. Drives with the status LED lit red may be hot-swapped.
12
Factory Use Only
13
Boot Mode Switch
58