Thermostat Information - Honeywell T7200D Product Data

T7200D,E, T7300D,E,F AND Q7300 SERIES 2000 PROGRAMMABLE COMMERCIAL THERMOSTATS AND SUBBASES
Set Program Start Time Set Day/Time
Em Ht
Aux Ht
Comm
Mon TueWedThuFriSatSun
Un Occupied 12 Override
System
Em Heat Off Cool Auto
Fig. 15. LCD display of all segments.
TEST NUMBER
Fig. 16. Test number display.
Table 8. Tests Available in Installer System Test.
Test
Number System Test Description
10 to 19 Heating equipment can be turned on and off.
20 to 29 Emergency heat equipment can be turned on and
off (Q7300C,D,H only).
30 to 39 Cooling equipment can be turned on and off.
40 to 49 Fan equipment can be turned on and off.
60 0 to Keyboard keys test.
60 19
70 to 79 Thermostat information including date code and
software versions are displayed.
NOTE: If a duct temperature sensor is installed
(T7300F only), duct temperature is also displayed.
Refer to Table 9 and Thermostat Information section for
directions and results of the specific system tests.
NOTE: Press Run Program to exit the system test. The
system test times out after four minutes without any
key presses.
63-4355—4
Temporary Setting Enrg
Sav
AM
Room
PM
%Humid
Heat Cool Remote
In Recovery Auto Only Duct
Lo Med Fan
Hi
Wait On Auto
M4916
M10257A

Thermostat Information

1. Press Heat/Cool Settings to access thermostat
information.
2. Press increase
The first two large digits are the month and the third digit
is the last digit of the year.
(Example: 036 = March 1996).
3. Press increase
identification code. (Example: 02 = software ID code 2).
4. Press increase
number. (Example: 001 = revision number 1).
5. Press increase
identification code. (Example: 314 = EEPROM ID 313).
6. Press increase
identification code.
(Example: HP = heat pump subbases).
7. Press Run Program to exit the self-test. The self-test
times out after four minutes without any key presses.
14
M4934
to display the production date code.
M4931
again to display the software
M4932A
again to display the software revision
M10229
again to display the EEPROM
M4933A
again to display the subbase
M10290