Thermostat Information - Honeywell T8611G Chmnothern IV User Manual

78611G CHRONOTHERM _ IV DELUXE PROGRAMMABLE HEAT PUMP THERMOSTATS
Refer to Table 5 for the directions and results of the NOTE: Press Time z_ to advance to the next test and
specific tests. Time V to go back to the previous test, Press
Run Program to exff the system-tast.
Table g. Installer Syatem-Test Options.
Key to I Test I Press Number Description
Heating Equipment Syatem-Teat
Time L_ 10 Enter heating equipment system-test.
• 11 Stage-one heat comes on. The system fan is also energized,
• 12 Stage-two heat comes on. Stage-one heat and system fan remain on.
• 11 Stage-two heat turns off.
• 10 Stage-one heat and system fan turn off,
Emergency Heating Equipment System-Teat
Time Z_ 20 Change from heating to emergency heating equipment system-test.
• 21 Emergency heat come on.
• 20 Emergency heat turn off.
Dooling Equipment Syatem-Teat
Time _, 30 Change from heating or emergency .heating to cooling equipment cystem-test.
• 31 Cool and system fan come on.
• 30 Cool and system fan turn off.
Fan Equipment System-Teat
Time A 40 Change from cooling to fan equipment system-tast.
• 41 Fan comes on.
• 40 Fan turns off.
Key Operation System-Teat
TJme_. I 60 2 _ Change from fan to key opera,on syst Eu3%_st.
I I
NOTE: Press any key and the disptaysd numbers will
change. Press Time ? to go to the previous test
and the Time _. to go to the next test. The Run
Program Key wilt not exit this test, To exit, press
Time _ or Time _7 and then the Run Program
key.
THERMOSTAT INFORMATION
1. PresstheTime_ key to access the tbermostat
information.
]D
M4_4
2. Press the increase • key to display the production
date code. The first two large digits are the month
and the third digit is the last digit of the year
(Example: 027=February 1997).
3. Press the increase • key again to displey the
software identification code. (Example: 02 =
software tD code 2)
4. Press the increase • key again to display the
software revision number (Example: 001=Revision
number t ).
5. Press the increase • key again to display the
EEPROM ider_tificstioncode. (Example: 314 =
EEPROM ID 314)
60-0936--1