Honeywell SMV 3000 User Manual page 146

11.4 Diagnostic Messages,
Diagnostic Messages,
Table 34
continued
SMV Status SCT Status Message SFC Display Message TDC Status Message
6-3 2 Wire TC PV3
6-0 2 Wire RTD PV3
6-1 3 Wire RTD PV3
6-2 4 Wire RTD PV3
4-3 PV2 Sensor = AP
4-4 PV2 Sensor = GP
- Write Protected
134
Continued
Informational Status Message Table
STATUS TAG ID. 2 WIRE TC PV3
2 WIRE TC PV3
STATUS TAG ID. 2 WIRE RTD PV3
2 WIRE RTD PV3
STATUS TAG ID. 3 WIRE RTD PV3
3 WIRE RTD PV3
STATUS TAG ID. 4 WIRE RTD PV3
4 WIRE RTD PV3
- STATUS 4-3
- STATUS 4-4
URV 1 . TAG ID.
WRITE PROTECTED
SMV 3000 Transmitter User's Manual
Possible Cause
PV3 input is being provided by
2-wire Thermocouple (T/C) type.
PV3 input is being provided by
2-wire RTD type.
PV3 input is being provided by
3-wire RTD type.
PV3 input is being provided by
4-wire RTD type.
Sensor type for the current SMV
is absolute pressure.
Sensor type for the current SMV
is gauge pressure.
- The value could not be written
because the transmitter is write
protected.
What to Do
Nothing – Information only. However,
this may indicate a problem if sensor
type does not match the sensor
physically connected to transmitter.
Nothing – Information only. However,
this may indicate a problem if number
of wires displayed does not match
number of RTD leads physically
connected to transmitter; or if sensor
type should be thermocouple.
Nothing – Information only. However,
this may indicate a problem if number
of wires displayed does not match
number of RTD leads physically
connected to transmitter; or if sensor
type should be thermocouple.
Nothing – Information only. However,
this may indicate a problem if number
of wires displayed does not match
number of RTD leads physically
connected to transmitter; or if sensor
type should be thermocouple.
Nothing – Information only.
Nothing – Information only.
The hardware jumper within the
device must be repositioned in order
to permit write operations.
1/99