Code 128 Message Length; Code 128 Code Page; Code 128 Function Code Transmit; Telepen - Honeywell 3800g User Manual

Code 128 Message Length

Scan the bar codes below to change the message length. Refer to
Length on page 7-2 for additional information. Minimum and Maximum
lengths = 0-80. Minimum Default = 0, Maximum Default = 80.
Minimum Message Length

Code 128 Code Page

Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the bar
code being scanned was created using a code page that is different from the
one the host program is expecting. If this is the case, scan the bar code below,
select the code page with which the bar codes were created from the chart,
Code Page Mapping of Printed Bar Codes
the SAVE bar code from the
manual. The data characters should then appear properly.

Code 128 Function Code Transmit

By default, Code 128 function codes are not transmitted with Code 128 bar
code data. However, if you wish to transmit Code 128 function codes with the
bar code data, scan the Function Codes On bar code, below.
* Function Codes Off

Telepen

3800g/3800gHD/3800gPDF User's Guide
Programming Chart
Code 128 Code Page
<Default All Telepen Settings>
Maximum Message Length
on page A-4, and scan the value and
inside the back cover of this
Function Codes On
Message
7 - 15