Laptop Direct Connect; Connecting The Imager With Rs-232 Serial Port - Honeywell 3800g User Manual

Laptop Direct Connect

For most laptops, scanning the Laptop Direct Connect bar code allows opera-
tion of the imager in parallel with the integral keyboard. The following Laptop
Direct Connect bar code selects terminal ID 03, programs a carriage return
(CR) suffix and turns on Emulate External Keyboard

Connecting the Imager with RS-232 Serial Port

1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the imager.
Note: For the imager to work properly, you must have the correct cable for your
type of terminal/computer.
3. Plug the serial connector into the serial port on your computer. Tighten the
two screws to secure the connector to the port.
4. Connect the power supply and plug into an outlet.
5. Turn the terminal/computer power back on.
Note: You will not hear a power-up beep because the 3800g is factory defaulted
to a USB connection. You must scan the
below to enable RS-232 ability.
1 - 6
Laptop Direct Connect
with CR suffix
3800g/3800gHD/3800gPDF User's Guide
(page 2-5).
RS-232 Interface bar code