Table of Contents
Advertisement
Installation and Setup
Connecting Alarms
22
Note
To ease installation, the terminal block can be removed. The power
connections of the removable terminal block are not polarity-sensitive.
Connect either power lead to either connector terminal.
3.
Secure the power leads by tightening the terminal screws until snug.
4.
Plug the power supply into an appropriate power source.
Note
For secure installations, surface-mounted cables should be protected by
plastic or metal cable covers.
Note
If your installation involves a 24V AC power source, then please wait
approximately 60 seconds after connecting to a power source for video to
appear on the local video out.
Caution
Installation must be performed by a qualified service technician. The
proper wire gauge for the distance and number of cameras must be
determined to maintain 24 VAC at each camera.
Caution
When powering the camera from 24 VAC, a UPS source should be
considered to ensure satisfactory performance.
Caution
Connect power either from a 24 VAC source or CAT5 Ethernet
connector (PoE); never both at the same time.
WARNING!
Do not exceed the maximum rating of 12 VDC, 0.5 A on alarm
output connections.
Advertisement
Table of Contents
