Cutter Deck Removal - Honda H5013 Owner's Manual

3. Cutter deck removal
- 1. Start the engine and move the hydraulic cylinder selector lever (op-
tional part) to the "FRONT" position. Raise the cutter deck by using
hydraulic lift lever.
- 2. Stop the engine and remove the engine switch key.
- 3. Set the gauge wheel to the 1 l/2 position (See page 34).
- 4. Lower the cutter deck; turn off the engine, remove the ignition key
and disconnect the spark plug.
m
To avoid severe personal injury remove the ignition key
and disconnect the spark plug cap to prevent accidental starting.
- 5. Remove the cutter deck drive belt from the pulleys. (See page 46).
- 6. Disconnect the front deck links by removing 14 mm lock pins and
washers on each side of the cutter deck.
WASHERS
h M
- 7. Disconnect the cutter deck lift plates and rear deck links by removing
the 14 mm lock pins and washers (two on each side) from the cutter
deck.
REAR DECK LINK CUTTER DECK LIFT PLATE
47