Mowing - Honda H5013 Owner's Manual

5. Mowing
Before operating this tractor you should read and understand the SAFETY
INFORMATION on pages 3-8.
l
Rotating blades and thrown objects can cause severe personal injury.
Always stop the engine before clearing the discharge cover.
l
Unseen hazards may cause loss of control or damage to the tractor.
Look for and avoid rocks, roots, holes, and hidden hazards in the
terrain.
l
Operating the tractor near the edge of a ditch or an embankment could
cause it to tip or roll over.
l
Certain maneuvers can cause the tractor to tip or roll over on sloping
surfaces; avoid sharp turns, rapid acceleration, and sudden stops.
Also, avoid backing down slopes.
l
Decomposing grass creates heat, and may become a fire hazard.
Always empty the grass bags before storing the tractor.
When mowing tall grass, make a first pass with the deck fully raised (4
inch position) this will help to expose any hidden obstacles. When you are
sure that the area is completely cleared, mow again at the desired height.
IMPORTANT NoTrCE If the tractor should accidentally get caught on an un-
seen object (rock, root, hole, etc.), do not attempt to ride over the obstruc-
tion or turn the steering wheel to free the mower. These actions can
damage the steering mechanism or the deck.
MOWING TIPS
1. Mow at full throttle to give a neat appearance to the lawn. The lawn
may not be trimmed uniformly at medium or low engine speeds.
2. Observe the following when mowing:
4th gear Heavy cutting or trimming
5/6th gear
Normal cutting
7th gear
Light cutting or transportation
8th gear Use only for transportation
3. Do not allow the grass to grow too long before cutting or trimming. Also
allow the lawn to dry thoroughly before you use the mower. To cut a
thick or lush lawn, mow at low speed or cut twice.
4. Always turn counterclockwise at low ground speed when cutting close
to trees, posts, sprinkers, walls, etc.
5. You may cut the lawn too short when the lawn is thick or wet, and/or
the ground is soft, due to sinking of the gauge wheels.
6. Increase the cutting height if the lawn is spindly, and the surface
uneven.
39