Honda Automobile Accessories Installation Instructions Manual page 8

23. Secure the disarm switch wire harness to the
disarm switch with one short wire tie, then attach
the harness to the driver's dashboard lower cover
with two halves of a cushion tape in the areas
shown. (Cut a cushion tape in half with scissors,
and use the two halves to secure the harness.)
CONNECTOR
CLIP
CONTROL
UNIT
BRACKET
24. Push the clip on the 3-pin connector of the disarm
switch into the hole in the control unit bracket.
25. From the driver's side, route the 14-pin connectors
of the security system wire harness to the left fuse
box. Unplug the 14-pin connector from the fuse
box, and plug the 14-pin connectors of the security
system wire harness in between.
14-PIN CONNECTOR
(VEHICLE HARNESS)
14-PIN CONNECTORS
(SECURITY SYSTEM
WIRE HARNESS)
8 of 12
DISARM SWITCH
SHORT
WIRE TIE
CUSHION TAPE
(Cut in half.)
LEFT FUSE
BOX
SECURITY SYSTEM
WIRE HARNESS
All 21624 (0008)
26. Attach the 14-pin connector of the security system
wire harness to the side of the vehicle connector.
SECURITY SYSTEM
WIRE HARNESS
14-PIN CONNECTOR
VEHICLE
CONNECTOR
27. Locate the two 2-pin connectors blue-taped to the
vehicle harness, and remove the blue tapes to free
the connectors. Plug the 2-pin connectors you just
freed into the 2-pin connectors of the security
system wire harness. Connect the blue 2-pin
connector of the vehicle harness to the blue 2-pin
connector of the security system wire harness.
2-PIN
CONNECTORS
(GRAY)
2-PIN
CONNECTORS
(BLUE)
© 2000 American Honda Motor Co., Inc - All Rights Reserved.
LEFT FUSE BOX
LEFT FUSE BOX
SECURITY
SYSTEM
WIRE
HARNESS