Advertisement
33. Remove the clip from the hole in the left knee
bolster, use a utility knife to cut the clip off of the
vehicle harness. Take care not to damage the
vehicle harness.
HARNESS CLIP
(Cut and discard.)
34. Assemble three fuse cases as shown. Attach the
appropriate fuse label to each fuse case of the
security system wire harness, then attach the red
connector clip as shown.
FUSE SEAL
(3 A)
6 x 12 mm
WASHER-BOLT
RELAY
BRACKET
VEHICLE HARNESS
35. Position one of the relay brackets on the left knee
bolster, and install one 6 x 12 mm washer-bolt and
6 mm flange nut. Push the red connector clip on
the fuse case of the security system wire harness
into the hole in the relay bracket.
36. Secure the security system wire harness to the
vehicle harness with one long wire tie in the area
shown.
10 of 12
LEFT KNEE
BOLSTER
VEHICLE
HARNESS
RED
CONNECTOR
FUSE SEAL
CLIP
(15 A)
LEFT
KNEE
BOLSTER
FUSE
CASE OF
SECURITY
SYSTEM
WIRE
HARNESS
6 mm
LONG
FLANGE NUT
WIRE TIE
37. Position the 5-pin and 4-pin relays onto the other
relay bracket, and install one 6 x 12 mm
washer-bolt and 6 mm nut.
RELAY BRACKET
6 x 12 mm
WASHER-BOLT
5-PIN RELAY
38. Plug the 6-pin and 4-pin connectors of the security
system wire harness into the 5-pin and 4-pin
relays; then attach the relay bracket to the steering
hanger beam with one 6 x 12 mm washer-bolt and
6 mm flange nut. (The 5-pin relay has a 6-pin
connector.)
6-PIN CONNECTOR
5-PIN
RELAY
4-PIN
6 x 12 mm
RELAY
WASHER-
BOLT
STEERING HANGER BEAM
All 21624 (0008)
About 45°
5-PIN RELAY
5-PIN RELAY
6 mm
FLANGE
NUT
© 2000 American Honda Motor Co., Inc - All Rights Reserved.
6 mm
FLANGE
NUT
4-PIN RELAY
4-PIN
RELAY
4-PIN
CONNECTOR
Advertisement
