Honda Automobile Accessories Installation Instructions Manual page 6

13. Measure and mark the upper steering column
cover.
5.5 mm
DRILL
UPPER STEERING
COLUMN COVER
20 mm
14. While wearing eye protection, lightly center-punch
the mark; then drill a 5.5 mm hole through the
upper steering column cover. Remove all burrs.
15. Route the terminal ends of the LED through the
hole you just drilled, and secure the LED with the
push nut. Install the push nut securely.
UPPER STEERING
COLUMN COVER
PUSH NUT
6 of 12
MARK
LED
PUSH NUT
16. Locate the 2-pin connector included in the kit, and
lower the lock. Firmly push the LED terminals into
the 2-pin connector.
17. Measure and mark the driver's dashboard lower
cover. (If necessary, remove the insulation.)
25 mm
18. While wearing eye protection, lightly center-punch
the mark; then drill a 12 mm hole through the
center-punched mark.
• First drill a pilot hole with a 10 mm bit, then
finish with a 12 mm bit.
• Remove all burrs.
All 21624 (0008)
Insert.
Lock.
WHITE WIRE
RED WIRE
First drill with a
10 mm bit, then with
a 12 mm drill bit.
MARK
BACK OF
DRIVER'S
DASHBOARD
LOWER COVER
15 mm
© 2000 American Honda Motor Co., Inc - All Rights Reserved.