Honda Automobile Accessories Installation Instructions Manual page 7

19. Route the terminal ends of the disarm switch
through the hole you just drilled, and secure it with
the washer and 12 mm nut from the kit.
DISARM SWITCH
20. Locate the 3-pin connector included in the kit.
Firmly push the disarm switch terminals into the
3-pin connector until they click into position, and
lower the lock. Slide the white connector clip onto
the underside of the 3-pin connector.
3-PIN
CONNECTOR
WHITE
CONNECTOR
CLIP
BLACK WIRE
© 2000 American Honda Motor Co., Inc - All Rights Reserved.
NUT
WASHER
DRIVER'S
DASHBOARD LOWER
COVER
Lock.
Insert.
BLUE WIRE
All 21624 (0008)
21. Push the wire tie with clip into the hole in the back
of the control unit bracket. Position the control unit
bracket on the driver's dashboard lower cover, and
install the three self-tapping screws from the
attachment kit.
WIRE TIE
WITH CLIP
BACK OF DRIVER'S
DASHBOARD
LOWER COVER
22. Position the control unit on the control unit bracket,
and install the two 4 x 30 mm washer-screws.
Secure the antenna to the control unit bracket with
the wire tie with clip you just installed, as shown.
Secure the antenna parallel with the control unit.
ANTENNA
WIRE TIE WITH CLIP
SELF-TAPPING
SCREW
CONTROL
UNIT
BRACKET
4 x 30 mm
WASHER-SCREW
CONTROL
UNIT
CONTROL UNIT
BRACKET
7 of 12