Advertisement
Adjusting the Control Unit
•
Use a small flat-tip screwdriver to change the
mode switch and the horn/siren switch and to
adjust sensitivity.
GLASS BREAKAGE
SENSOR
MIN MAX
Mode Switch:
•
Set the mode switch according to the customer's
choice.
•
Refer to the Owner's Manual for the explanation of
each mode.
Horn/Siren Switch:
•
Set the switch to "HORN" in normal use. If an optional
siren is installed, set the switch to "SIREN."
Glass Breakage Sensor:
•
Do not attach anything like scotch tape over the
holes; this is the microphone pickup.
Sensitivity Adjustment Knob:
•
Adjust the sensitivity only if the customer requests
it; the sensitivity adjustment of the glass breakage
sensor is factory set.
•
Be careful when you adjust the sensitivity; if you
raise the sensitivity too much, the security system
can give a false alarm, and if the sensitivity is too
low, the security system may not work even if
glass is broken.
© 2000 American Honda Motor Co., Inc - All Rights Reserved.
MODE SWITCH
AUTO LOCK
AUTO
MANUAL
SENSITIVITY
ADJUSTMENT
KNOB
SIREN
HORN
HORN/SIREN
SWITCH
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your car. These procedures should not
be attempted by "do-it-yourselfers."
1.
Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2.
Disconnect the negative cable from the battery.
3.
Inside the passenger's compartment, remove the
front console lower cover (four retaining clips).
FRONT CONSOLE
LOWER COVER
If the vehicle you're working on is equipped with an
optional ashtray with cigarette lighter, continue with
step 4, if not go to step 5.
4.
Remove the ashtray with cigarette lighter, (two
self-tapping screws, one connector, and four
retaining clips).
ASHTRAY WITH
CIGARETTE LIGHTER
SELF-TAPPING
SCREWS
All 21624 (0008)
CLIP
CONNECTOR
CLIP
3 of 12
Advertisement
