Honeywell HVE1 Getting Started Manual page 11

Rear Panel
Interface Element
1 ALARM IN
2 ALARM OUT
3 RS-232
4 RS-485
5 RESET
6 microSD
7 LAN
8 DC12V
9 GND
Figure 7 HVE4 Rear Panel
Table 5 HVE1 Rear Panel
Function
Relay alarm input.
Relay alarm output. The maximum voltage/current supported by the
relay output is 12 V / 1 A.
Serial interface for configuring the encoder's parameters, or for using
as a transparent channel.
RS-485 connection for pan, tilt, zoom control.
Restore to the factory default settings by holding the RESET button
for more than 15 seconds after the power is turned on.
microSD interface for data storage, up to 32GB, Class 6 and above.
10M/100Mbps adaptive Ethernet interface (PoE).
The right LED indicator lights green when the network cable is
connected. The left LED indicator blinks orange when data is
transmitting/receiving.
12 V DC power supply
Ground
Note The HVE4 model encoder does not support/supply a beeper/audio alert.
| 17
800-15611V2 - A - 10/2013