Casio CW-50 User Manual page 71

When printing in both the upper label area (LABEL 1) and
lower label area (LABEL 2)...
7. Rotate the disc 180 degrees and place it back onto the tray.
8.
Repeat steps 3 and 4 to position the disc.
Note
See "Positioning the Disc on the Tray" for more information.
9.
Click Start Printing.
This starts the second printing.
Important!
• Never disconnect the AC adaptor, power cord, or USB cable while a
print operation is in progress. Doing so creates the risk of malfunction.
The disc tray opens automatically after printing is complete. Carefully
pull out the tray and remove the disc.
Position the disc so the first
printing is located here, and
then set the disc onto the
tray.
Positioning the Disc on the Tray
Use the positioning guide to adjust the position of the disc on the tray in
the following cases.
• When the label of the disc already has logos or other markings
• When performing separate upper block and lower block printings
When the label of the disc already has logos or other markings
Note that you cannot print over a logo. Position the disc so the logo or
other markings on the disc label are not inside the shaded area.
When performing separate upper block and lower block printings
Before performing the second printing, rotate the disc 180 degrees. Next,
position the disc so the first printing is within the shaded area.
Printing will be
performed inside the
area indicated by the
guidelines on the
disc tray.
Guidelines
Area of first
printing
Area of second
printing
69