Basic And Advanced Settings - NETGEAR ProSafe WC7520 Reference Manual

Figure 6.
Note: The Network navigation menu tab displays under the Monitor main
navigation tab only when you have configured stacking.
For information about the layout and general characteristics of the web management
interface, see
For information about the network status and related information, see
Wireless Controller Summary Screen
3. Configure the wireless controller and your network:
a. RF planning. Follow instructions in
location of the access points.
b. Configure your network. Follow the instructions in
configure your network, including the SSIDs, security, MAC ACLs, captive portal,
QoS, rate limiting, and so on.
c. Set up the wireless controller. Follow the instructions in
page 26 to select the type of deployment for your network.
d. Add the access points. Follow the steps in
discover your access points and add them to wireless controller's managed access
point list.

Basic and Advanced Settings

You can deploy the wireless controller in a small wireless network with 10 or 20 access points
or in a large wireless network with up to 150 access points. Small networks require a basic
configuration, but large networks can become very complex and require you to configure the
advanced features of the wireless controller.
ProSafe 20-AP Wireless Controller WC7520
Web Management Interface Layout
Chapter 3, RF
Introduction and Overview
21
on page 18.
on page 168.
Planning, to plan the number and
Chapter 4
System Planning
Access Point Discovery
View the
through Chapter 10 to
on
on page 49 to