Cisco DPC2203C Installation And Operation Manual page 40

Chapter 2 Installing the DPC2203C for Internet Service
7 After the system finds the USB driver, the Digital Signature Not Found window
opens and displays a confirmation message to continue the installation.
8 Click Yes to continue the installation. The Found New Hardware Wizard
window reopens with a message that the installation is complete.
9 Click Finish to close the Found New Hardware Wizard window. The USB
drivers are installed on your PC, and your USB devices are ready for use.
10 Try to access the Internet. If you cannot access the Internet, go to
Troubleshooting the Installation (on page 35). If you still cannot access the
Internet, contact your service provider for further assistance.
Installing USB Drivers on Windows 98SE and Windows ME Systems
Insert the USB Cable Modem Driver Installation Disk into the CD-ROM drive
1
of your PC.
2 Wait until the POWER and ONLINE LED status indicators on the front panel of
the cable modem illuminate solid green. The Add New Hardware Wizard
window opens.
Click Next in the Add New Hardware Wizard window.
3
4 Select Search for the best driver for your device (Recommended) in the Add
New Hardware Wizard window, and then click Next.
5 Select CD-ROM drive in the Add New Hardware Wizard window, and then
click Next.
6 Select The updated driver (Recommended) in the Add New Hardware Wizard
window, and then click Next.
7 Click Next in the Add New Hardware Wizard window. The Copying Files
window opens. After 10 to 20 seconds have passed, the Add New Hardware
Wizard window reopens.
8 Click Finish. The USB driver installation is complete.
24 72-4017315-01 Rev B